(1) ONLY 1994 NISSEI MODEL FS210S50ASE INJECTION MOULDING MACHINE equipped with 8000F Controller
SPECIFICATIONS
CLAMP UNIT
Clamp force: 233 U.S. Tons
Distance Between Tie Bars (HxV): 22.5" x 22.5"
Platen size (HxV): 32.5" x 32.5"
Maximum clamp stroke: 21.7"
Mould shutheight: 10.4" to 19.7"
Maximum daylight: 41.4"
Hydraulic ejector stroke: 4.7"
INJECTION UNIT
Shot size: 13.5 oz. G.P.P.S. (A)
Injection Pressure: 28724 PSI
Screw diameter: 1.97"
Screw speed: 0-190 RPM (low torque)
0-150 RPM (high torque)
ELECTRICAL UNITPump motor: 40 HP
Primary voltage /phase/cycle: 575/3/60
Heater voltage/phase/cycle: 230/3/60
Control circuit: 24 volt DC
NOTE: Heater voltage requires separate 230 volt supply
GENERAL
Machine weight: 10.6 U.S. Tons
Hydraulic oil quantity requirements: 206 gallons
Pump motor: 40 HP
Primary voltage /phase/cycle: 575/3/60
Heater voltage/phase/cycle: 230/3/60
Control circuit: 24 volt DC
NOTE: Heater voltage requires separate 230 volt supply
280ton Nissei FN6000 (1997)
New Arrivals - 2 Available!
1997
NISSEI 308US Tons Injection Machine, Model FN6000-INJ.71A, 29.7 oz Injection Shot Capacity, 26 x 26 Tie Bar Spacing, 37.6 x 37.6 Platen Size, 25.7 x 37.5 Maximum Mould Size, 45.3 Maximum Daylight, 32.6 Stroke, 5.1 Ejector Stroke, NC9000F Controller, Core Pull, 575 V equipped with
9000F Controller TACT Controller 9300T Controller 9000F Controller
Used Equipment may have had modifications made to them that En-Plas Inc. is unaware of and take no responsibility for.
Specifications listed on our used equipment pages may differ from actual specifications on the equipment and are meant solely as a guideline.
