(416) 286-3030 blemieux@en-plasinc.com
NEW ARRIVAL

Used 1999 FN7000 Nissei (400ton)

Used Nissei Model FN7000-100A hydraulic molding machine equipped with 9300T controller.

SPECIFICATIONS

CLAMP UNIT

Clamping force:                                                   398 U.S. Tons

Clamping stroke                                                  970 mm (38.2”)

Minimum mold thickness                                    350 mm (13.8”)

Maximum daylight opening                                1320 mm (52.0”)

Clearance between tie bars (HxV)                      735 mm x 735 mm (28.9” x 28.9”)

Die plate dimensions (HxV)                                1055 mm x 1055 mm (41.5” x 41.5”)

Min. mold dimensions (HxV)                             520 mm x 520 mm (20.5” x 20.5”)

Locating ring diameter                                        101.6 mm (4.0”)

Ejector stroke                                                       150 mm (5.9”)

INJECTION UNIT

Screw diameter:                                                   80 mm (3.15” -C)

Shot size:                                                              42.9 oz. G.P.P.S.

Injection Pressure:                                               18,490 PSI

ELECTRICAL UNIT

Voltage including heater and motor/phase/cycle: 575/3/60

 GENERAL

Hydraulic oil quantity requirements:                  980 litres

* Oil can be supplied by En-Plas at an additional charge

MACHINE EQUIPPED WITH THE FOLLOWING:

  1. 1. Standard single core pull
  2. Spare parts package
  3. Cycle counter
  4. Centralized manual lubrication system
  5. Screw cold start preventing circuit
  6. Hydraulic oil temperature upper and lower limit warnings
  7. Water saver valve
  8. Mounting pads
  9. Hopper magnet
  10. Mould clamps
  11. Air blow off circuit
Used Equipment may have had modifications made to them that En-Plas Inc. is unaware of and take no responsibility for. Specifications listed on our used equipment pages may differ from actual specifications on the equipment and are meant solely as a guideline.