(416) 286-3030 blemieux@en-plasinc.com
SOLD

Used Nissei FN110 Year 2007

Late Model Year 2007 En-Plas Nissei Model FN110-18A Injection Molding Machine

With TACT Controller

SPECIFICATIONS

CLAMP UNIT

Mold clamping force:                                          123 U.S. Tons

Mold clamping stroke                                          520 mm (20.47”)

Minimum mold thickness                                    200 mm (7.87”

Maximum daylight opening                                720 mm (28.35”)

Clearance between tie bars (HxV)                      420 mm x 420 mm (16.54” x 16.54”)

Die plate dimensions (HxV)                                607 mm x 607 mm (23.90” x 23.90”)

Ejector stroke                                                       85 mm (3.35”)

INJECTION UNIT

Screw diameter:                                                   36mm (1.42”-A)

Shot size:                                                              4.9oz. G.P.P.S.

Injection Pressure:                                               32280 PSI

Screw speed:                                                        0~290 RPM

ELECTRICAL UNIT

Pump motor KW:                                                18.5

Primary voltage/phase/cycle:                               575/3/60

Heater voltage/phase/cycle:                                 230/3/60

Control circuit:                                                     24 volt DC

NOTE:  Heater voltage requires separate 230volt supply

 GENERAL

Hydraulic oil quantity requirement:         390 litres (not included)

 WITH THE FOLLOWING:

  1. 1. Dual core pull
  2. Cycle counter
  3. Centralized manual lubrication system
  4. Screw cold start preventing circuit
  5. Hydraulic oil temperature upper and lower limit warnings
  6.    Air blow off circuit

 

Used Equipment may have had modifications made to them that En-Plas Inc. is unaware of and take no responsibility for. Specifications listed on our used equipment pages may differ from actual specifications on the equipment and are meant solely as a guideline.