Used Nissei FN8000 500ton 1999 with 9300T Controller with capability to go a larger shot size
ONLY USED 1999 NISSEI MODEL FN8000/200B INJECTION MOLDING MACHINE
WITH NC9300T CONTROLLER and brand new pump
SPECIFICATIONS
CAMP UNIT
Clamp force: 501 U.S. Tons
Molding clamp stroke 1025 mm (40.35”)
Minimum mold thickness 375 mm (14.76”)
Maximum daylight opening 1400 mm (55.12”)
Clearance between Tie Bars (HxV): 820 mm x 820 mm (32.28″ x 32.28″)
Die plate dimensions (HxV): 1190 mm x 1190 mm (46.85″ x 46.85″)
Ejector stroke: 160 mm (6.30”)
INJECTION UNIT
Screw diameter: 90 mm (3.55″-B)
Shot size: 67.10 oz
Injection Pressure: 22,823 PSI
Screw speed: 0-135 RPM High torque
135-185 RPM Low torque
ELECTRICAL UNIT
Pump motor: 75 kw
Primary voltage/phase/cycle: 575/3/60
Heater voltage/phase/cycle: 230/3/60
Control circuit: 24 volt DC
NOTE: Heater voltage requires separate 230 volt supply
GENERAL
Hydraulic oil: 1360 litres
MACHINE EQUIPPED WITH
* SPI Standard core pull A or B or C
* Centralized manual lubrication system
*. Used mounting pads
* Hydraulic oil temperature upper and lower limit warnings
*. Cycle counter
*. Water saver valve
* Screw cold start preventing circuit
* Air blow off circuit
* Machine colour Nissei green