Used Year 2001 Nissei Model FN7000-100A Injection Molding machine with 45038 HRS
With NC9300T Controller, 80 mm barrel & screw
SPECIFICATIONS
CLAMP UNIT
Mold clamping force: 397 U.S. Tons
Mold clamping stroke 970 mm (38.19”)
Minimum mold thickness 350 mm (13.78”)
Maximum daylight opening 1320 mm (51.97”)
Clearance between tie bars (HxV) 735 mm x 735 mm (28.94” x 28.94”)
Die plate dimensions ( HxV) 1055 mm x 1055 mm ( 41.54” x 41.54”)
Ejector stroke 150 mm (5.91”)
INJECTION UNIT
Screw diameter: 80mm (3.14”)
Shot size: 42.85 oz. G.P.P.S. (C)
Injection Pressure: 18486 PSI
Screw speed: 0-120 RPM Constant torque
120-190 RPM Variable torque
ELECTRICAL UNIT
Pump motor kW 37
Primary voltage/phase/cycle: 575/3/60
Heater voltage/phase/cycle 230/3/60
Control circuit: 24 volt DC
NOTE: Heater voltage requires separate 230 volt supply
GENERAL
Hydraulic oil quantity requirements: 980 litres
CONTROLLER – NC9300T FOR NISSEI FN SERIES MACHINE
Electronic controller with 6 speeds/3 holding
pressure and 3 limit pressure profiling, shot discrimination
and mold open/close linear encoders, colour screen and graphics,
and 1 floppy disk,
Including:
High resolution colour 10.4″ touch flat screen.
30 mold storage in machine with removable disk drive to store up to 100 mold set-ups with 1 floppy disk.
Input/output analog displayed with explicit error messages.
RS232 port for printer
PID Control for barrel and oil with auto tuning on nozzle
Proportional control of the pump for all functions of the machine
Linear encoder for measurement of clamp, injection, ejection position
Optically isolated control system (Protection from electrical noise).
Real time graphics for injection functions.
Auto purging
6 step injection speed profiling.
6 step injection pressure profiling (3) fill, (3) hold.
Sprue break
Digital back pressure
2 speeds for plasticizing
3 mold opening and closing speeds plus 2 stage high pressure clamp.
Multi-stage hydraulic ejector control
Set value graphics for profiles for injection.
Interlock for part detection (not including sensor).
Core pull control software.
Graphic and alpha-numeric printing capability
Injection boost to hold switch over by time, position, hydraulic pressure or cavity sensor (individually or in combination)
Air blow software control
Real time clock
Cycle time monitoring and analysis
Interface for standard plant monitoring systems.
History reporting of machine cycle conditions and set-up changes
Quick machine set-up via a single page
Forced reject count.
Clamp retry up to 2 times.
Digital display of screw position, ejection and clamp with bar display of current position
Standard graph display for injection profile
Monitor tolerance window can be assigned for reject outputs.
Out of 17 processing variables, 8 can be recorded an 4 can be selected and displayed.
Graphic printouts can be generated. Average and standard deviations are calculated. Printer
not included.
SPC option
Standby temperature program so when machine goes into alarm temperature drops to standby
(selectable for on/off).
High/low oil temperature alarm with solenoid control of water to maintain set temperature
Emergency temperature off for lights out operation selectable on/off
Calculator
Total run time.
Grand total shot display.
Calendar function to turn barrel heat on automatically with option to add dryer, mold temp controller and spare
Unique machine identification through the controller Alpha numeric characters
Ejector backward confirmation by position through front screen
Mould ejector plate backward confirmation input software included (hardware extra)