9300T Controller for Nissei Machines
TOP OF THE LINE NC9300T CONTROLLER
Electronic controller with 6 speeds/3 holding pressure and 3 limit pressure profiling, shot discrimination and mold open/close linear encoders, colour screen and graphics and 1 floppy disk
Including:
High resolution colour 10.4″ touch flat screen.
30 mold storage in machine with removable disk drive to store up to 100 mold set-ups with 1 floppy disk.
Input/output analog displayed with explicit error messages.
RS232 port for printer
PID Control for barrel and oil with auto tuning on nozzle
Proportional control of the pump for all functions of the machine
Linear encoder for measurement of clamp, injection, ejection position
Optically isolated control system (Protection from electrical noise).
Real time graphics for injection functions.
Auto purging
6 step injection speed profiling.
6 step injection pressure profiling (3) fill, (3) hold.
Sprue break
Digital back pressure
2 speeds for plasticizing
3 mold opening and closing speeds plus 2 stage high pressure clamp.
Multi-stage hydraulic ejector control
Set value graphics for profiles for injection.
Interlock for part detection (not including sensor).
Core pull control software.
Graphic and alpha-numeric printing capability
Injection boost to hold switch over by time, position, hydraulic pressure or cavity sensor (individually or in combination)
Air blow software control
Real time clock
Cycle time monitoring and analysis
Interface for standard plant monitoring systems.
History reporting of machine cycle conditions and set-up changes
Quick machine set-up via a single page
Forced reject count.
Clamp retry up to 2 times.
Digital display of screw position, ejection and clamp with bar display of current position
Standard graph display for injection profile
Monitor tolerance window can be assigned for reject outputs.
Out of 17 processing variables, 8 can be recorded and 4 can be selected and displayed.
Graphic printouts can be generated. Average and standard deviations are calculated.
Printer not included.
SPC option
Standby temperature program so when machine goes into alarm temperature drops to standby
(selectable for on/off).
High/low oil temperature alarm with solenoid control of water to maintain set temperature
Emergency temperature off for lights out operation selectable on/off
Calculator
Total run time.
Grand total shot display.
Calendar function to turn barrel heat on automatically with option to add dryer, mold temp controller and spare
Unique machine identification through the controller Alpha numeric characters
Ejector backward confirmation by position through front screen
Mould ejector plate backward confirmation input software included (hardware extra)